Capacitance Level Switch

We call this series the “Intelligent Capacitance Level switch series”. And we do so because this level switch has a microprocessor that checks the complete system (including itself) before validating a signal. You will see a flashing green LED that serves as heartbeat to indicate a healthy system. In the case of a system fault ,which may result due to incorrect wiring, open or short sensor connection, inadequate probe insulation improper grounding or electronic insert failure, the heartbeat stops fault LED glows, display indicates “E---“ and the relay contacts revert to their fail-safe condition.

The MP-SLC level switch is a highly reliable liquid and solids level indicator. A two wire Pulse Frequency Modulation (PFM) is used for interference-free signal transmission between probe and evaluation unit. Complete system is checked before each measurement and the system has a provision for auto-compensation for temperature drift in the vicinity of a pre-amplifier.

The MP-SLC... series exhibits a high degree programmability. Important functions such as operating mode (independent/pump control), delayed switching for probe covered/uncovered conditions, fail safe high/low, switching sensitivity, switching delay and set point calibration are programmable via a keypad. You can store the programmed parameters in a non-volatile memory indefinitely requiring no battery backup.